Post by hogkiller on Dec 22, 2015 21:00:05 GMT -5
For some reason this was the build from hell,,if anything could go wrong it did with these blades. From the initial grind to finish these baby's took there toll on my old arse. 
He's been very patient with me and i thank you very much sir,,because of that each blade has different custom pin material and different colored vulcanized liner material,,blue,green,black and red.
His is the one on top,,it has crosscut walnut with red liners,,,one of the only things that didn't go wrong,,crosscut usually tends to end up warping on me once the epoxy hit's it.
Just need to clean them up a bit and add a few coats of poly and they'll be on the way,,,oh yeah,,,one more thing,,as i was fitting them to the sheaths i sliced right through one,,so it continues,,,
Anyhow,,these are big belly drop point's at 9" oal length with close to a 4 1/2" cutting edge with walnut handles.
Sorry for the lousy indoor pic.
He's been very patient with me and i thank you very much sir,,because of that each blade has different custom pin material and different colored vulcanized liner material,,blue,green,black and red.
His is the one on top,,it has crosscut walnut with red liners,,,one of the only things that didn't go wrong,,crosscut usually tends to end up warping on me once the epoxy hit's it.
Just need to clean them up a bit and add a few coats of poly and they'll be on the way,,,oh yeah,,,one more thing,,as i was fitting them to the sheaths i sliced right through one,,so it continues,,,
Anyhow,,these are big belly drop point's at 9" oal length with close to a 4 1/2" cutting edge with walnut handles.
Sorry for the lousy indoor pic.
